Most reacted posts

So, Is it possible these fans can ramp speed vs temperature? I haven't seen an answer about that yet. Maybe a future FW upgrade can unlock it. Like what is that fan 'slope' setting on the app.

So its wall mount but don't fully wall mount it. Deceptive if true.

Yes, you can use the inverter only. My 2009 MS4024 I did just that. Was to old to have the custom battery profile inputs. I did use the generator occasionally to charge Li battery's just kept an eye on it and shut gen off at the voltage I wanted.

Is there some sort of filter device that can clean up a Gens dirty sinewave?

Update: I've decided to move the well closer to my house solar system shed so I can run 240V split phase AC to it. Also looking at a grundfos 5-SQ. Much easier this way. Well getting drilled in a few weeks then I can decide what exact model to get depending on the depth. It wont need to run...

Dayum!! $2600 for a Grundflos SQflex 6 SQF-2 (2-wire) AC/DC pump and another $480 for the controller/monitor. Too much $$$$. Whats this 3-wire, all the MPPT and starting circuits are not on the pump? I dont see a grundos that fits that bill and can run DC.

Been eyeing this Firman, its the smallest Dua/Tril fuel 120/240v with electric start. But THD is 11 to 14%. RUNNING WATTS: 4000(Gas), 3600(LPG), 3200(NG) STARTING WATTS: 5000(Gas), 4500(LPG), 4000(NG) Firman T04073

OK, doesn't seem to be working. On 2 separate 3 day long stents I set up 6000xp as Lead acid to top balance, bulk 56.2v and Float 54v. It followed the lead acid voltages just fine. When going back to Lithium-SOC mode its still barely getting over 54v for bulk and floating around 53.5v. So...