Most reacted threads

This is a balance of easy ( for me ) to make and the MANY smart folks discussing. I chose Poron 1/4 foam separators in a oak box with neoprene side / bottom cushions the "front" is easy to disassemble for upgrades ( bms , cells maybe ) the case compresses the foam by 25%, the bus bars (72mm flex...

So my setup: I have a Sol-Ark 15K and have done the full home backup route... So I installed a 200AMP fused disconnect ( ebay special Square-D monster 3 phase for 160$ w/fuses ) That went well and I have 4/0 AL into and out of the disconnect into the 15K Grid terminals ( SEU AL 4/0 - that was...

I am in a quandary with Schneider vs Victron. I would like to use Victron 48v/10000/230v50hz with autotrans but am concerned that it wont pass a local inspection (UL issue ) I have seen only one comment: agillis answered · Nov 09 2020 at 9:26 PM IEC is just as good of a safety certification...

The Schneider ac couple doc says - The XW Pro can be connected in various configurations from just a single unit to multiple units in parallel, or in a three-phase configuration. Regardless of the system configuration however, the maximum continuous allowable rating of AC-coupled PV inverter(s)...