Myoffgridsolarsystem

Hello alll, Worked with SS they had me take a LCD screen from a working battery and put it back into the one that was not allowing me...

Hello I have had 4 EG4-6500ex inverters running no problem. I did not see you stated that you connected the current sharing cables to...

Hello all, I received the BMS and took photos of the removal and install but just sent all to SS Ethan and Chris from SS resolution...

Do you think I have any issue with the inverters the way I see it on the LCD screens. Do you think it is operating correctly? I do not...

I really appreciate your help Rich I am very new to this Forum and I do not even know where to post this type of question any help on...

First photo is master inverter connected to load L1 second photo load L2 Third photo slave inverter for photo L2 fifth photo, master...

Understood so if I’m seeing 107 watts on the master inverter and about 98 to 100 Watts on the slave inverter are those numbers combined...

Not sure if you seen this photo, but these inverters are not connected to any loads except for the power distribution block. I have not...

So 107 watts from the master and about 82 watts from the slave is that considered idle consumption or is that because the load breakers...

I also thought in standby mode. I should only see a idle consumption of like 18 wants per inverter that would be a total of 36 watts

So if it’s not out putting any loads I’m seeing like 120 to 124 wants it fluctuates so when both load breakers are on both inverters I...

I have have double checked all the torque settings on both EG4-18 KPV’s All communication cables are working as they should. My issue is...

Hello all, I have 2 EG4-18KPV Inverters with batteries connected and loads from the inverter connected to one PDB and it’s funny I see...

Hello, I have been working with Ethan Klein Technical Support Associate at SS and they have decided to send me a new BMS. Ethan says...

Hello for members, I have 24 EG4-LL batteries everyone of my batteries. I can go into the protocols and select the lux power for RS485...