Robbert's latest activity

You may be able to purchase three victron lynx power ins locally, at marine stores etc. good for 1000A.

You aren't balancing the cells as much at that voltage. But if that's good enough for you, that's all that matters.

All of my battery connections are well crimped and sealed with heat shrink, and don't really need any additional maintenance or special...

You are right. A balancer does not make any sence to add to batteries in parallel.

It doesn't have to be much higher than 3.45. I charge to 55.8 (3.48) per cell. Absorbtion is 30 minutes and usually there is a...

You can't balance at 3.45v. That's where balancing should start. (Not finish) You are just at the top of the flat part of the charging...

If you have functions that you want to engage based on any of the three parameters. Let's say you have an inexpensive inverter with no...

A firmware update to version fAAB-1717 seems to have fixed the issue. Been running for a little over month with no issues so far.

Zero is fine. As long as you understand that Zero is 2.5v per cell. (Not dead) I don't cycle below 3v (unless testing) because I want...

One cycle is defined as fully charged to fully depleted to fully charged again. 100% to 0% to 100%. My 1st pack was commissioned...