-
-
I doubt there is any real surge to contend with. Is there something special to be concerned? -
I had to throw away the cables that came with one of my inverters. Correct size, but made from CCA verse pure copper. If you choose to...
-
Morning. I am excited about the possibilities this forum can provide! We are doing a few solar project at the ‘farm’. We have a house...
-
I have no tips for your system, but wanted to say I also have an aerobic system, regular flush toilets, and it uses no power, only...
-
SupraSPL reacted to time2roll's post in the thread Can someone test the t class fuses? For littlefuse (blue sea) and south bend? with
Like.
Class T will pass 200% rating for close to a minute according to the Blue Sea graph. I would keep these a bit tight as they are short... -
SupraSPL replied to the thread Blue Seas 150amp ANL Fuse Discolored. Why?.That is oxidation and it can happen from heat and or fumes. It happened to my cheap Amazon 250A ANL fuse and it was definitely hot...
-
SupraSPL reacted to Suijkerbuijk's post in the thread Blue Seas 150amp ANL Fuse Discolored. Why? with Like.
I think its the plastic from the anl That some chemical fumes come from some heat on the fuse. Better brand will not have it . Or its...
-
I swapped out the EPever controller for a Victron. I did change the settings on the EPever. However, I felt that overall it was not...
-
SupraSPL reacted to Pierre's post in the thread Fuse between battery and shut off switch? with Like.
In all my builds I put a fuse in as close as possible to the +ve terminal of the battery.
-
The fuse should be as close to the battery as is practicable.
-
The system needs to be shut down from the batteries to loads.
-
SupraSPL replied to the thread Input charge voltage getting stuck?.Did you find out if it was the float voltage setting too high?
-
SupraSPL reacted to Suijkerbuijk's post in the thread Input charge voltage getting stuck? with Like.
Set your systeem settings. I think your systeem float is to low. Epever have set a update later that the float is higher . If you have a...
-
Pretty sure this is a known bug in epever charge controllers. They don't 'mppt' and just stay locked on their early morning voltage...
-
SupraSPL reacted to RangeyRover's post in the thread Bluetti AC200MAX 700w 12V-48V DC-DC charging $150 with Like.
Hi All, I've successfully setup my AC200MAX for 700w DC-DC charging for about $150 USD. In my case it's from a 12V 560Ah Battery bank...
-
You want a contactor that has low standby current, called "Economizer" coils. However, that is still a 24/7 parasitic load. I solved the...
-
I had 4 chargery on my 4 banks. They were very inconsistent with readings and reliable current measurements. The DAY I installed my JK...
-
The 24v 8S DIY packs I am working with have balanced well. Am adding a portable 24v system and am already considering picking up another...
-
Looks like $290 Vatrer has bluetooth with cell voltage monitoring.
-
Do any of these 100ah budget batteries have BMS with Bluetooth that report each cell voltage?
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…