Most reacted threads

I hadn't seen this posted, so if it's old news, I apologize. Recently I was without my phone for a bit and wanted to check remotely on my setup at the cabin. I wished there was a simple way to view the info I see from the WatchPower app on my PC. I went through my router logs to see where...

Batteries often advertise a certain number of cycles - many Lifepo4 are in the 3000 to 6000 rating. But what defines a cycle? I get it from a full discharge to a full recharge. But what about 'cycles' that drain 10 or 20% of available energy, and then gets recharged. is this also a cycle?

I have a simple setup I built to power my small garage/shop. All in One MPP LV2024, and 6 24v 100ah backup batteries (14.4kwh) with 800w of solar. Works great, meets my needs. It recently dawned on me, that if I added a second LV2024, and a parallel kit, I could have a powerwall for home...

newbie question I'm having trouble locating answers to Do solar combiner boxes wire the panels in Series or Parallel, or is it configurable?

I need ~ 10kWh of battery storage. (4 batteries of either 12v200ah or 4 24v100ah) the kWh is the same between a 12v200ah and a 24v100ah, but the 12v batteries are about $130 less. Is there a reason (aside from having to series connect a few extra in the 12v scenario) for picking the 24v...

This only happens when powered by batteries. It’ll send out 60hz/120v for 3 or 4 seconds. Then drops to 0 for a second or two then cycles again Batteries are at 27.6v. Any ideas?

At my remote cabin, I've seen that each night at 11pm, my grid usage spikes. I've looked through all my MPP 20204's settings and can't figure out what might be triggering this? It's not from unexpected load Any suggestions?

Just setup a MPP Solar LV2424 - and I'm loving it. The unit came with two cables, one an RS232 to serial port, and the 2nd a USB cable that goes from the USB out of the LV2424 to the USB in on a PC. Other's I see have acquired a serial port to USB adapter to connect the unit to the PC - I'd...