Recent content by VladG

The constant MAX_RESPONSE_WAIT_MS represents the actual wait time. I believe I used 1000 for this constant.

I didn't use 8 at all - not required. In addition, you have to wait for the response. The unit is fairly slow. Just wait for the response and you will get it. Plz refer to the method "execute" in the attached class. The code is not final, however, I constantly get the response from the charger.

Ok, I was able to resolve the problem. I can now easily communicate with the charger. Thank you for the help.

Hi steviep19. Again, thank you for the help. I cannot communicate with the device. Could you please confirm which RS485 connector wires you used for the communication with the charger? Based on the attached documentation these are 1 (B+) and 2 (A-). Have I gotten it correctly? Did you use the...

Thank you steviep19! Match appreciated.

Hi steviep19, were you able to communicate with the unit via RS485? Did it work for you?

Hello. I have an ESmart3 40A charge controller (I think this is IPanda unit ) that was working fine in my cottage for two years. At some point, I discovered that it displays a battery charge voltage equal to 5V while I have 12-volt batteries. The tester showed the right voltage of 13 something...

Thank you! I guessed that would be the case. Is the minimum voltage can be altered via changes in software or it is in the hardware?

Hi BlitzSSS, Please let me know if you found a solution? I ordered 8s JBD but the seller from Aliexpress sent me the 15s one instead :) . I'm trying to figure out if I can use the received BMS in my 8s set up by joining some balance connectors. I will be happy to hear that it is possible. Thank...