Good Morning. I've gone through the videos and have Will's Mobile Solar Power book, and have a few basic questions regarding fuses. I want to make sure they are in the correct location and correct size. Max energy draw will be 20A (LED lights, small pump for mattress, iPhones). My setup I'm building is a 100W Renogy Flexible panel that will be mounted to camper roof, connected to a Renogy 20A Rover MPPT charge Controller, connected to a 105AH AGM Battery. The Battery will be connected to a Fuse Block with a Disconnect Switch (to turn off power to the Fuse Block) between the Battery and Fuse Block. The attached drawing shows how the setup will be. My questions on fuses,
1) I believe I should have a Bolt-On Fuse attached to the Battery between the Charge Controller and Battery; am I correct? What size should I have here?
2) I believe I should have another fuse to the Charge Controller that will be 25-30A (I plan on a 30A ANL fuse here; am I correct? If not, what should I have here?
3) Do I need a fuse between the Battery and Disconnect Switch, or is that the bolt on fuse to the battery?
Any other suggestions would be very helpful.
1) I believe I should have a Bolt-On Fuse attached to the Battery between the Charge Controller and Battery; am I correct? What size should I have here?
2) I believe I should have another fuse to the Charge Controller that will be 25-30A (I plan on a 30A ANL fuse here; am I correct? If not, what should I have here?
3) Do I need a fuse between the Battery and Disconnect Switch, or is that the bolt on fuse to the battery?
Any other suggestions would be very helpful.