derbuechsenmacher
New Member
- Joined
- Apr 19, 2022
- Messages
- 8
As part of my project I will be mounting panels to a metal roof. I’ve seen videos of rv installs with no drilling (in fact I have done this on my OFFGRID camper setup - camper is stationary on a piece of property, so I don’t need to worry about them coming off going down the road). The building is an all steel building with a relatively shallow roof pitch, so in this case I’d like to angle the panels about 30 degrees). In my camper I went low tech using 2inch aluminum angle screwed into the frame and industrial adhesive to the roof. I was thinking of something similar here, just using some bigger angle so I can have a pivot on the bottom bracket, and some structure on the top mount. Any suggestions