oblongataman
New Member
I looked in the Schneider reference materials and unfortunately came up short. The installer manual and the user manual reference the Auxiliary (Aux) Port on the bottom of the Conext XW Pro and similar XW and XW+ units but do not specify the type and spec for the connector on the interface board.
The male connector on the interface board measures 18.7 mm from side to side and 7.2 mm high. This matches with spec for terminal block connectors with a pitch of 3.5 mm (Pitch x N + 1.2).
These can be found through several outlets and may also be referred to as terminal block connectors or phoenix connectors.
And since you are here looking for info on the Aux connector, here is the pinout info from the installer manual:
I hope this helps save someone some time in the future.
The male connector on the interface board measures 18.7 mm from side to side and 7.2 mm high. This matches with spec for terminal block connectors with a pitch of 3.5 mm (Pitch x N + 1.2).
These can be found through several outlets and may also be referred to as terminal block connectors or phoenix connectors.
And since you are here looking for info on the Aux connector, here is the pinout info from the installer manual:
Pin | Reference | Name | Function |
JU-1 | AUX+12V | +12 V User Voltage Supply | +12 VDC Voltage source: 250 mA maximum |
JU-2 | AUX-RPO | Remote Power Off | Remote Power Off Logic Level: Active Low. Activating this signal shuts down system operation |
JU-3 | AUX-COM | Common Ground Reference | Return Common Ground Reference for 12 V, Remote Power Off signals |
JU-4 | EXT_TS_OUT | External Transfer switch: Output signal | Open collector type drive circuit (30V/0.5A max) |
JU-5 | EXT_TS_IN | External Transfer switch: Input signal | External Transfer switch: Low signal range: (0-5V) High signal range:10-28V with the consumption of 8mA@12V and 10mA@24V |
I hope this helps save someone some time in the future.