Sungoldpower 48v 6000w low frequency inverter

[Blown284]

Trying to figure out how to get the "auto sense" to actually work on my 48v sungoldpower low frequency inverter. I set dip switch 3 to "1" and it still is not working. Any ideas?

 

[seneysolar]

They usually don't recognize small loads. My Aims takes something over 200W to kick on, so I don't use the power saver feature.

 

[Blown284]

Trying to figure out how to get the "auto sense" to actually work on my 48v sungoldpower low frequency inverter. I set dip switch 3 to "1" and it still is not working. Any ideas?

Auto sense = power save. It says when it detects power draw more than a certain amount of watts, it will automatically turn on. It pulses every few seconds. That feature doesn't seem to be working for me despite trying to pull around 1000 watts from it in

They usually don't recognize small loads. My Aims takes something over 200W to kick on, so I don't use the power saver feature.

I'm trying to pull about 1000watts from it. Does it matter if the load is on Hot 1 or Hot 2? I tried both and getting no luck.