Victron 712 mid point alarm

[Roadrunner27]

Not sure what's going on. Have just one battery installed a couple of months ago along with a BMV 712. Seemed okay but now have an alarm going off for mid point deviation showing around - 99.6%
Tried recharging and rebooting BMV but no change. Battery at 13.3
If it matters it's a Power Queen 200AH. Did try starting the generator recently and it was still connected to house batteries so it didn't like that, cranked over for a bit and then tripped something, heard the BIRD trip. Have since rewired generator to chassis battery only. Not sure if this has anything to do with my problem.
Thanks for any help you could offer, have been trying to look for something similar on here. Have read a lot of posts and tried searching for answer but really haven't had any luck.

 

[sunshine_eggo]

Go into Misc and set Aux input to none:

 

[Roadrunner27]

Can't get to settings in app cause the alarm is in place and won't seem to allow it. Appears like I have to clear alarm first?
Thanks and appreciate response

 

[chrisski]

A screen shot of what you're seeing will help.

Victron not letting me in the app for me has only been I forgot the pin I put in years prior.

 

[mikefitz]

Victron not letting me in the app for me has only been I forgot the pin I put in years prior.

The PUK code needed, this is on a label on the device.
Go to the device list, click on the 3 dots.
see 3.3

3. Connecting

www.victronenergy.com