carmensandiego
New Member
- Joined
- Apr 26, 2021
- Messages
- 5
Hi everyone,
I've been lurking for a while but this is my first post!
My boyfriend and I are building up our 2013 AWD Toyota Sienna. So far, we've installed a 3.5" lift, insulation and the subfloor. Now I've been put in charge of the electrical planning. I've never done any electrical work before, so tear apart this diagram before I burn our van down
Note: the diesel heater is intentionally bypassing the low voltage protection - the heater can melt down if the power is disconnected before it can complete it's 10 min cool down cycle.
I do have a couple questions:
1.) How do I size the ground wires? Same size as the corresponding positives?
2.) Should I be using a bus bar instead of attaching 3 wires directly to the battery terminals?
3.) Does anyone have recommendations for a good/cheap battery monitor?
Thank you!!