Is there some kind of sequence on connecting two charge controllers by Victron? Everytime I try to connect them together, everything freezes, and I can’t get any panel to bring in electricity. And a fuse stops working or the other charge controller doesn’t recognize the system?
Or the software connect on my iPhone doesn’t recognize the other charger, so I delete from Bluetooth, only to find I can’t get it back again?
There must be some kind of sequence on two or more charge controllers by Victron. I’ve looked everywhere for it and cannot find this information!
Has anyone else encountered this, or is there a correct way to do one charge controller and then slowly add more? ?
I’m using ANL fuses, perhaps these are the wrong type? There’s some kind of short going on here.
I have six 100 amp hour battle born batteries wired in 24 V.
Or the software connect on my iPhone doesn’t recognize the other charger, so I delete from Bluetooth, only to find I can’t get it back again?
There must be some kind of sequence on two or more charge controllers by Victron. I’ve looked everywhere for it and cannot find this information!
Has anyone else encountered this, or is there a correct way to do one charge controller and then slowly add more? ?
I’m using ANL fuses, perhaps these are the wrong type? There’s some kind of short going on here.
I have six 100 amp hour battle born batteries wired in 24 V.
Attachments
Last edited: