Dan Sinclair
New Member
- Joined
- Mar 7, 2020
- Messages
- 24
1 - Do my Grounds look correct? See Green wires, they are terminating where original ground is tied to frame.I am installing a solar system that is a completely separate system from the factory DC system that comes with our travel trailer. The secondary system is intended to supply 120V power to a couple of 120V receptacles when dry camping. The original DC system will supply all 12V requirements as it did from the factory. I did add a second cheap battery that matches the original cheap battery of the original system as well as an ammeter to monitor the original DC system. The new system has 4 - 100W solar panels, a 2200 watt inverter, a 40 Amp MPPT Solar Controller and two SOK 100AH LiFePO4 Batteries. I have questions regarding the following on my wiring diagram attached.
2 - The original DC system has a Battery cut off switch on the positive side, I am placing the cut off on the negative side on the new as shown on wiring diagram that came with the switch?
3 - Do my fuses/circuit breakers look correct?
Thanks for looking I appreciate it!
Dan
Attachments
Last edited: