MrM1
I'm Here, But I'm Not All There
I am doing a bit of experimentation here. Using the voltage calibration tool for the SCC, I have arbitrarily set the voltage 2.5 v dc above actual battery voltage. Then set the bulk / absorb change out voltage about 0.8v higher than the "calibrated" battery voltage of the SCC.
I discharged the batteries to 80%, and began charging. So the batteries are actually at 53.8, but the SCC "thinks" the voltage is 56.5. And when setting bulk/absorb to 57.5 ... so far I have observed the SCC stopping charge to that batteries 3 times. So I am testing this to see where it leads using higher bulk/absorb voltages. But so far using this method I have been able to get both the charge amps and charge volts to stop at cut off.
I discharged the batteries to 80%, and began charging. So the batteries are actually at 53.8, but the SCC "thinks" the voltage is 56.5. And when setting bulk/absorb to 57.5 ... so far I have observed the SCC stopping charge to that batteries 3 times. So I am testing this to see where it leads using higher bulk/absorb voltages. But so far using this method I have been able to get both the charge amps and charge volts to stop at cut off.