corn18

I use the Blue Sea circuit wizard for designing. http://circuitwizard.bluesea.com/ Yes, 175A is 2000W / 0.84% efficiency / 13.6V.

When I design a system, I assume that a single battery may have to power the whole system. In this case, a 2000W inverter is 175A from...

Coolio 2 ga is the correct size for the batts to the buss bars. It is good for 175A. Put a 200A MRBF fuse on each battery positive...

Is your trailer 30A or 50A service?

Ugh. Maybe I'll let prices fall a bit more before filling up that Lynx.

I agree with one caveat, Install a battery monitor that tracks volts/amps. This way you will know where you stand then add your "bits"...

So would it be fair to recommend a drop in LiFePO4 and then upgrade parts as able? I look back on my three previous trailers I had with...

The higher operating voltage of LFP means converters will rarely trigger re-bulk. You can typically force this with a power cycle -...

I am cornfused. My system is all set up for LiFePO4 charging and I rarely ever see more than 13.6V charging. I think I have seen 14.2V...

Yup, BT only.

Anyone know if it works with the SOK BMS? I will check the next time I am at the camper but thought maybe someone knew already.

I have 3 SOK BT battteries and the app for them can only connect to one battery at a time. I want to see all of them at once. Is there...

Great album.

In my experience, it takes a few cycles to get the SOC calibrated.

Haven't met a 200W panel that can hit an Imp of 16.7A. My 200W mono panels are 10A. Best 3 can do is 30A.

No butyl tape, no lap seal, oh the horror!

Unistrut

Love my unistrut.

Yup. Battery to Lynx.

The inside of those hex crimps is solid copper. The individual strands are cold welded together and that is cold welded to the lug.