michvhf

I had my camera but didn't bring the big lens or tripod. Finally looked at the photos, and got one almost decent one.

Didn't get total here, SE Mich. It got a little dimmer. I have the panels on a solar tracker, as it got close to the darkest it was...

Laws like this aren't written or usually not even reviewed by politicians. Lobbyists' lawyers write the law, hand it to the pols and...

Scope creep -- lets not go there. I started with a really old Tektronix 535. Then went to a 545B, then all hell broke loose. I sold a...

I recently got the last available Sumry 4KW AIO that was listed on ebay. I have it installed and it seems to be working ok so far...

It would be interesting if you post up a review of the Sumry over on the AIO Forum. If you can find a board number (The SRNE units have...

I saw some other comments regarding the Sumry. There are two versions, 230 volt and 120 volt (different wattage versions for both as...

So much for that idea. I bought the last one!! So far it's working well - only been on a couple of days tho.

I have the MOES thing and while it switched nice between grid and inverter, when the inverter went into alarm and cut off (more on that...

It's fine to have multiple charge sources connected. The tricky part is getting them to do what you want them to, like if the grid...

If I charge from the grid, I use an AIMS 120 VAC to 24 VDC 37.5 amp converter. I’ve never needed to use that, but I test it every year...

In the rare case my solar did not keep up in the RV I would flip the breaker on to use the on-board converter/charger. Otherwise any...

Ok, thanks!

24V. I'm mainly concerned with a charger and external mppt connected to the batteries.

Subject says it all. Every separate system I see a schematic for only shows the battery, inverter and mppt controller. None show any...