Would it be ok to wire this switch on the ground side so I can use a shunt to monitor each battery separately? Attached is a drawing on what I was thinking. Or would there be a better way?
Thanks
Do my settings look correct...off Grid no utility power, currently have a 2000 watt Honda generator that I was going to tie into inverter.
48v 555 ah flooded battery bank, batteries are Deka auto batteries for now until I can get something better.
2800 watt of panels
Guys. I’m swapping out my Mpp 5048 for some more power, going from a 5kw to 12kw will I need to upgrade my battery bms and fuses?
I currently have 2 - 48v 280ah battery packs with the Jbd 200a BMS on each pack. 200a fuses protecing each battery and 2/0 battery cables.
What do I need to...
I will be adding 2- Seplos 48v 280ah battery boxes to my existing system which consists of 2 - 48v 280 ah homemade battery packs.
All of the batteries are Eve cells. I was planning on wiring the 4 battery packs to a common Busbar and to the inverter from there.
Inverter is a Growatt SPF 12k...
Hello,
Im Looking to purchase a couple BMS for My system. I was looking at the overkill solar that are rated for 100 amps, as they sound the most durable? If my inverter draws roughly 100 amps (5000watts) and I have 2 battery banks, would that work? Or do I need to look into a different...
Hello I have 2 of each of these panels and wanted to wire all 4 of them in series, but I see the amp rating is a little different between them.
is it close enough to wire in series?
I just installed a chargeverter and currently have the negative going to the busbar where I have 2 battery packs connected. I would like my battery gauge to read this charge I’m putting back into the batteries. Question…can i hook the negative of the charger to the inverter negative at the...
Guys, I need to upgrade my current 5048 as I'm maxing it out occasionally.
I was looking at the EG4 6000 EX-48HV split phase, getting 2 of them and wiring in parallel.
Or would the Growatt SPF 12000 split phase be a better option?
What's your thoughts? What's the pros and cons. The Growatt...
Hello I was wondering if this would work...
I currently have a Mpp 5048 48 volt charge controller in a small solar shed. At the time I only have room to mount the 4 - Renolgy 100watt panels i currently have and was planning on buying 2 Trina 310 watt panels.
Charge controller will handle 145voc...
Guys,
I have 2 battery banks and it seems bank 1 is out of balance that I top balanced initially.
What do you think?
Also what do you suggest my BmS settings be at, I would like to cap charging at 80-85%.
From what I’ve read they say not to balance until 3.4v?
It seems my settings got goofy on...