I found similar thread with manual and looks they ship these sensors with each bms.
https://diysolarforum.com/threads/jbd-200a-4s-wiring.38525/
And someone posted images for the exact sensor but still no clue.
https://diysolarforum.com/threads/jbd-200a-4s-wiring.38525/post-606993
I want to install a 110/240 V socket into my campervan and connect Bluesmart IP 22 to charge the leisure batteries. It will only be used to charge the battery and nothing else. My question is, do I still have to install an MCB/RCB, or would the Bluesmart circuit protection be enough?
no manual. The bms comes with two temperature sensors already connected. Yes I assume this is high temperature sensor however no idea where should I connect there is no plug but two naked wires.
I bought 4, 280Ah grade A LiFePO4 cells for a 12V battery pack. I put everything together, fully charged, discharged, and charged again.
The cell voltage difference during discharge stays at 0.001 all the way to the bottom.
Should I have to balance the cells?
Victron Orion rated to 30a however, you would never see that specially as it warms up.
I had 55a output before the last firmware update.
My actual question. Can I connect each Victron Orion to the each battery separately and what is the best method please?
Hi everyone
I have two 12v 320ah lifepo4 batteries connected in parallel. And two Victron Orion 12/12/30a chargers connected in parallel as well. However, with new firmware upgrades Victron Orion in parallel wouldn't charge battery higher than 38a but if I connect separately each would give...