6000XP not pulling power from batteries

[Woolval]

Good morning. Yesterday I just got my 6000XP running. Everything LOOKS good but the monitor app shows my load is not using battery power, just using grid power. It currently shows 16W going into my 6000XP from batteries, but not going out. I'm sure I have something set incorrectly but damned if I'm seeing it! I am confused by the setting under the MAINTENANCE tab. Any initial settings advice will be greatly appreciated.

6000XP
2) EG4 Lifepower4 Lithium 48V Batteries (both have the firmware update)

 

[Woolval]

Update: On the Maintenance tab I RESET everything to DEFAULT. It is now pulling power from my batteries. Now I need to figure out a working set of settings on the AC Charge options. Again, any advice is appreciated.