Hi all, been a little while anyway I’ve been running my small setup for most of this year and has been running a treat. It’s a 24v off grid system so no mains tie in etc.
I’ve had to take down my panels due to bad weather so had the solar side disconnected but kept the system powered on to keep tabs on the batteries via the shunt etc and minimal charging for phones etc.
I’ve reconnected the system this morning and everything working fine. However I’ve always had the input wattage and amps tally up with the whats being drawn until today and it’s baffling me as why it’s now different.
Roughly speaking 200w coming in, 200w being drawn has lead to 0.00 amps going into the battery.
Today I’ve got ~ 200w coming in and 285w being drawn yet the shunt is reading +1amp going into the battery so I am assuming the shunt is having a mare?
Any suggestions or anything I’ve missed?
Cheers all.
I’ve had to take down my panels due to bad weather so had the solar side disconnected but kept the system powered on to keep tabs on the batteries via the shunt etc and minimal charging for phones etc.
I’ve reconnected the system this morning and everything working fine. However I’ve always had the input wattage and amps tally up with the whats being drawn until today and it’s baffling me as why it’s now different.
Roughly speaking 200w coming in, 200w being drawn has lead to 0.00 amps going into the battery.
Today I’ve got ~ 200w coming in and 285w being drawn yet the shunt is reading +1amp going into the battery so I am assuming the shunt is having a mare?
Any suggestions or anything I’ve missed?
Cheers all.