RichardMole
New Member
- Joined
- Dec 6, 2022
- Messages
- 15
I have four Dyness B4850 batteries. I see that there is a 'Dyness Smart' smartphone app, and I assume that I should be able to monitor the batteries using it. When you first run the app you get the opportunity to link it to the batteries. I have tried following the instructions but without success. According to the instructions one has to put the battery into 'pairing mode' by:
- Power on the device (presumably the battery)
- Power off after 10s and then power on again
- Hold the reset button for 5s (presumably the red button on the battery marked SW)
- Confirm the indicator (presumably the Run LED) is blinking rapidly
- etc
But when I follow these steps and press the reset button, all the LEDs go out and the Dyness app doesn't detect the battery.
What am I doing wrong?
Thanks in advance.
- Power on the device (presumably the battery)
- Power off after 10s and then power on again
- Hold the reset button for 5s (presumably the red button on the battery marked SW)
- Confirm the indicator (presumably the Run LED) is blinking rapidly
- etc
But when I follow these steps and press the reset button, all the LEDs go out and the Dyness app doesn't detect the battery.
What am I doing wrong?
Thanks in advance.