Epever and float parameter

[frankz66]

Hello everyone, I wanted to ask why if after selecting a float of 13.73 and a boost reconnect, reading the monitor about 13.00 volts the controller does not go into boost. Does more time have to pass or is this parameter related to other parameters or time that has to elapse?

 

[Any name you wish]

How long did you wait for the boost to reconnect? Also, why does yours show commas instead of periods?

 

[lightbulb]

My experience is the same on every epever I have and had. I guessed it was a time thing but never found any data. Thanks for asking the question. Hope someone has something concrete.

 

[frankz66]

My experience is the same on every epever I have and had. I guessed it was a time thing but never found any data. Thanks for asking the question. Hope someone has something concrete.

Thank you for answering .

 

[frankz66]

How long did you wait for the boost to reconnect? Also, why does yours show commas instead of periods?

It is probably the decimal factor chosen in the operating system, also if you look at the commas they are both in the parameters I have indicated and by those it proposes