Solarismus
New Member
- Joined
- Jun 11, 2021
- Messages
- 5
Hey ho,
I was always very satisfied with my epever charge controller but fore some reason the load data have gone crazy. The chart controller is normally showing how much the devices that are connected draw, but when the device draws more than 1 Amp, the display says 0 Amps. If the devices draw less then one amp, the charge controller show the correct current.
I really have no clue why is this happening. I already checked the fuses but they seemed alright.
Any suggestions ?
thank you in advance
I was always very satisfied with my epever charge controller but fore some reason the load data have gone crazy. The chart controller is normally showing how much the devices that are connected draw, but when the device draws more than 1 Amp, the display says 0 Amps. If the devices draw less then one amp, the charge controller show the correct current.
I really have no clue why is this happening. I already checked the fuses but they seemed alright.
Any suggestions ?
thank you in advance