Would it cause any problems to connect 4 topband 3.2v/25ah packs in parallel with one copper bus bar rather than 4 separate ones?
CORRECTION... ( I was still asleep!!!)
I did not state my question correctly... I should have said "TWO buss bars ( one for each polarity) instead of Six ( three to span 4 terminals)".
I bought copper bar and it takes less to make two long ones than six short ones. PLUS it should have less resistance in one piece than overlapping them... right?
CORRECTION... ( I was still asleep!!!)
I did not state my question correctly... I should have said "TWO buss bars ( one for each polarity) instead of Six ( three to span 4 terminals)".
I bought copper bar and it takes less to make two long ones than six short ones. PLUS it should have less resistance in one piece than overlapping them... right?
Last edited: