Hey, so I currently have two LV6548’s in split phase powering my home with two 16s 280ah packs in parallel (off grid).
Within the home I have two large loads which I switch remotely as needed. They are a hot tub and electric water heater. Both consume around 5000ws. I tested the inrush surge on both and were within range for the inverter specs.
All has been good with the above. Yesterday I decided to watch a movie on the projector and it kept turning off incrementally. I intially thought it was the bulb needing replacement or some kind of fault. Today mid movie, I turned off the Hottub heater (remotely) and it turned the projector off. (Repeated the same process to confirm).
So my guess is that the large reduction in power from the hot tub turning off is causing the projector to shut down.
The projector is wall mounted and everything is hidden/in wall so I can’t see where I could put any line-conditioning/ups equipment.
I have a Panamax Max-In-Wall Power-Pro-PFP, (2) 15A OUTLETS, Surge Protection, EMI/RF Filtration connected and plan to bypass it to see if it may be tripping based on the reduction in voltage.
I looked up softstarters but it appears the interaction isn’t on the ramp up of power.
Any suggestions on solutions would be appreciated!
Within the home I have two large loads which I switch remotely as needed. They are a hot tub and electric water heater. Both consume around 5000ws. I tested the inrush surge on both and were within range for the inverter specs.
All has been good with the above. Yesterday I decided to watch a movie on the projector and it kept turning off incrementally. I intially thought it was the bulb needing replacement or some kind of fault. Today mid movie, I turned off the Hottub heater (remotely) and it turned the projector off. (Repeated the same process to confirm).
So my guess is that the large reduction in power from the hot tub turning off is causing the projector to shut down.
The projector is wall mounted and everything is hidden/in wall so I can’t see where I could put any line-conditioning/ups equipment.
I have a Panamax Max-In-Wall Power-Pro-PFP, (2) 15A OUTLETS, Surge Protection, EMI/RF Filtration connected and plan to bypass it to see if it may be tripping based on the reduction in voltage.
I looked up softstarters but it appears the interaction isn’t on the ramp up of power.
Any suggestions on solutions would be appreciated!