I can make you one outta 10awg cable and drop it in the mail, pm me your contact info..... no cost, just pay it forward.I'm looking for a set of quality, pre-built power output cables for my RD6018w power supply. Hoping to find spade terminals on the supply end and M6 ring terminals on battery end. Any suppliers come to mind?
Mine are 2 feet so I think 3 feet will be fine. There will be a little more voltage drop but not enough to be concerned about.@Gazoo @OffGridGuy THANKS for the link and review. I will order today.
Is 3-foot a good length for the cables? If so, I can make three sets of cables, with different terminals (bananas, spades, rings, gator clips, etc).
I have a few sitting around, takes about two minutes to make with a good crimp tool and stripper. Yes, spade terminals and 1/4 ring terminals.I'm looking for a set of quality, pre-built power output cables for my RD6018w power supply. Hoping to find spade terminals on the supply end and M6 ring terminals on battery end. Any suppliers come to mind?
I used their 10 gauge wire.This is the wire I ordered. I really like it.
Amazon.com: BNTECHGO 12 Gauge Silicone Wire 10 ft red and 10 ft Black Flexible 12 AWG Stranded Copper Wire: Car Electronics
Anyone know of a source for the decent quality banana plugs?BTW, use spade terminals on the Riden side, since the covers for the banana jack don't unscrew all the way. Either that or get some high quality banana jack plugs.
Fork spadeAnyone know of a source for the decent quality banana plugs?
Source spade terminals for 10 AWG is a PITA, also. But that's what I'm doing.