Firstascent
Solar Enthusiast
- Joined
- Mar 7, 2020
- Messages
- 265
So I was looking into the Victron Lynx Distribution setup as I really like the design of it for my DC loads and I came across this photo (attached) in the manual for it and it got me thinking about using it to parallel my cells together.
since this is able to be fused for each of the four connections, what would be any cons to using this to attach each of my 4s batteries to it to make them 4s4p?
off the top of my head, there would be more large wires having to connect each 4s to the distribution unit as opposed to just connecting the entire 4s4p bank to it with a single pair of 4/0 wires.
The positive side is that it would be very easy to take a 4s bank out of service if a cell goes bad etc.
My battery bank is 16 LFP 280ah cells which will be a 12v config in 4s4p and will be installed on my RV.
Any other cons you guys can think of doing it this way?
since this is able to be fused for each of the four connections, what would be any cons to using this to attach each of my 4s batteries to it to make them 4s4p?
off the top of my head, there would be more large wires having to connect each 4s to the distribution unit as opposed to just connecting the entire 4s4p bank to it with a single pair of 4/0 wires.
The positive side is that it would be very easy to take a 4s bank out of service if a cell goes bad etc.
My battery bank is 16 LFP 280ah cells which will be a 12v config in 4s4p and will be installed on my RV.
Any other cons you guys can think of doing it this way?