Hi,
I have the victron smartsolar mppt 75/15 bluetooth (brand new), a renogy 100w panel (brand new) and an eco-worth 12v lifepo4 battery (brand new).
I did plug everything in order and i did set the preset to lifepo4 mode.
I do not get current/amps.
I only see voltage of the PV and the voltage of the battery and no amps.
The pv show 20.45v and battery show absorb at 14.20v then after the 2 hours it show float at 13.50v
I did check every fuse and wire and everything is ok.
The battery show 12.94V with a multimeter, the solar panel wire show 21v, 2A (low sun) today.
When testing the PV on the victron screw with multimeter it show 1.9A
When connecting to the victron mppt the battery show 14.2v (absorb) and no amps.
Both solar panel and battery show 0 amps and 0W on the victron connect.
When plugged to the mppt it goes in bulk for like 2 seconds then to absorption then float after the 2h setting.
I also did test with different setting like 14.4 absorp and 13.8 float... and still same result. no amps at all.
I dont have load on and the mppt should be activated because I get 20v+ at solar and it is more than 5v over the battery stage.
What is wrong?
The battery have a bms inside is this brand not compatible with victron?
I have the victron smartsolar mppt 75/15 bluetooth (brand new), a renogy 100w panel (brand new) and an eco-worth 12v lifepo4 battery (brand new).
I did plug everything in order and i did set the preset to lifepo4 mode.
I do not get current/amps.
I only see voltage of the PV and the voltage of the battery and no amps.
The pv show 20.45v and battery show absorb at 14.20v then after the 2 hours it show float at 13.50v
I did check every fuse and wire and everything is ok.
The battery show 12.94V with a multimeter, the solar panel wire show 21v, 2A (low sun) today.
When testing the PV on the victron screw with multimeter it show 1.9A
When connecting to the victron mppt the battery show 14.2v (absorb) and no amps.
Both solar panel and battery show 0 amps and 0W on the victron connect.
When plugged to the mppt it goes in bulk for like 2 seconds then to absorption then float after the 2h setting.
I also did test with different setting like 14.4 absorp and 13.8 float... and still same result. no amps at all.
I dont have load on and the mppt should be activated because I get 20v+ at solar and it is more than 5v over the battery stage.
What is wrong?
The battery have a bms inside is this brand not compatible with victron?