I have the EG4 3000 EHV-48
Only one on right now but I have 2 for split phase (it is not hooked up currently)
When I run my heat gun on low it triggers the forever beep, the red fault light and it says [16]Error in the screen
It ONLY does it with the heat gun on low. On high it doesn't do it, running saws doesn't do it, I also ran another resistive heater and it doesn't do it.
Plugged all into gfci and it works fine doesn't trip. Also CAFCI breaker is fine also tried on grid and it works with CAFCI/GFCI too
I've ran several things as I said, saws, other heaters, computers, nothing trips it at relatively same wattage as the heat gun at low (~500watt)
Also which fault code is it? There are two different ones..
On page 29 I see this:
page 46:
here are some videos:
rotate through some info
demonstrate the fault
Only one on right now but I have 2 for split phase (it is not hooked up currently)
When I run my heat gun on low it triggers the forever beep, the red fault light and it says [16]Error in the screen
It ONLY does it with the heat gun on low. On high it doesn't do it, running saws doesn't do it, I also ran another resistive heater and it doesn't do it.
Plugged all into gfci and it works fine doesn't trip. Also CAFCI breaker is fine also tried on grid and it works with CAFCI/GFCI too
I've ran several things as I said, saws, other heaters, computers, nothing trips it at relatively same wattage as the heat gun at low (~500watt)
Also which fault code is it? There are two different ones..
On page 29 I see this:
page 46:
here are some videos:
rotate through some info
demonstrate the fault
Last edited: