Most reacted posts

https://www.amazon.com/gp/aw/d/B08T5Z72JW?psc=1&ref=ppx_pop_mob_b_asin_title

It shows on the bottom V display.

It doesn’t spike to 30v however it goes to 19v and shut off again.

It can take up to 48v but it is currently registering 12v. Which is correct.

So now the F04 error is gone and now getting F05 which I think is a ground fault. However it does show me a place to connect the grounding wire given. I know the picture below isn’t correct but I’m going to try changing to neutral.

Yes it is. It’s on the bottom part of screen. You just can’t see it.

inverter in shutting down and then spikes to 30v. Comes back on and then voltage drops and it shuts off. Cycle repeats.

It’s a 12v

It is expecting 12V.

With that has been said am I able to use the 36v panels with the 12v batteries that I have and 12v inverter? Or does the controller handle that?

So I sent back inverter and I was sent another. It seemed to work but with a different issue.

Current Setup: 3000W Inverter 12V Controller 2-100W panels 2-100ah 12v Batteries I connected everything and lights came on. A few minutes later inverter shut down and restarted. 2-3 minutes later it repeated. Continues but at random times. What could be causeing this? I’m using the space...

So even though I was sent new inverter it could still be bad?

I have and update. I purchased another inverter, however it wasn’t a pure sine. I bought a modified sine. I know it is recommended against it but I thought it could work for what I was doing. It is a Topbull 3000w Inverter. I plugged it in and light work great. No surge or shortage. I...

Here is a picture of my setup. I don’t have a breaker between my battery and inverter yet because I wanted to see if the new inverter would work without issue.

The only breakers I currently have is between battery/controller and panel/controller.

Yes, I am.

Here is my current setup.

Here is a link to a video of what it is doing. https://share.icloud.com/photos/074ifWZSybeNtuPMimSZCHUwg It turns on an then restarts EPEVER 40A MPPT controller 3000W Inverter Deep Cycle MightyMax Battery. Yes, battery is fully charged Voltage is 12V from battery. I haven't plugged in AC...

I don't think the inverter is getting hot. It has a fan and it goes on and off. Here is a link to a video of what it is doing. https://share.icloud.com/photos/074ifWZSybeNtuPMimSZCHUwg