n February 2023, EG4 announced a significant change to how their inverters do grounding and bonding. Overall, these changes allow for much greater flexibility in installing the inverter in ways that are both supported and meet the NEC requirements for grounding and bonding. This document describes what was announced and goes into detail on how to use the information to properly set up a system using the EG4 6000 EX inverter.
This is the video they released to announce the changes.
In June 2023, EG4 released a single version of the firmware that allows the user to select Mobile or Stationary bonding behavior.
The new firmware versions are available at https://eg4electronics.com/downloads/
WARNING: The designs shown in the document are based on the information EG4 has provided. However, I have not personally tested all of them.
This is the video they released to announce the changes.
In June 2023, EG4 released a single version of the firmware that allows the user to select Mobile or Stationary bonding behavior.
The new firmware versions are available at https://eg4electronics.com/downloads/
WARNING: The designs shown in the document are based on the information EG4 has provided. However, I have not personally tested all of them.