Hey all
I know the topic of cell compression has been discussed heaps and I'm looking into how best to do it for my situation, I was most likely going to use hose clamps at the top, bottom and middle of the cells with alloy C channel to locate the hose clamps and keep the cells really flat.
However one thing that concerns me is that these cells do not sit perfectly flat together and if I apply the middle hose clamp too tight I could actually be compressing the cells into a slight concave shape.
If I was to make something sit flat on the ends so this pressure is not applied in the middle, these cells still have these gaps running between. I have attached a picture.
Any advice on this please?
Thanks
I know the topic of cell compression has been discussed heaps and I'm looking into how best to do it for my situation, I was most likely going to use hose clamps at the top, bottom and middle of the cells with alloy C channel to locate the hose clamps and keep the cells really flat.
However one thing that concerns me is that these cells do not sit perfectly flat together and if I apply the middle hose clamp too tight I could actually be compressing the cells into a slight concave shape.
If I was to make something sit flat on the ends so this pressure is not applied in the middle, these cells still have these gaps running between. I have attached a picture.
Any advice on this please?
Thanks