Hi everyone,
I got a 100ah 12v Lifepo4 prismatic cell pack on a Daly 100A BMS with bluetooth.
I have set the DalyBMS sleep setting to 15300 so it doesnt fall asleep and I can check whenever I want the state of the pack.
In the last few days, I have put my CPAP with a 12v adapter on this battery pack to test it in off the settings.
After two 7 hours night of sleep, the Bluetooth app still says my battery is at 100% of soc.
When the CPAP runs at low setting, it doesnt draw much in terms of AMP. Below 2 amps for sure, maybe 1 amp. The Daly/app doesnt seem to detect that such current is being drawn. So I think the Daly BMS is not sensitive enough to detect under 2 amps current. Thus the app stays at 100% all the time.
Am I right in my thinking ? any settings I should look into ?
I got a 100ah 12v Lifepo4 prismatic cell pack on a Daly 100A BMS with bluetooth.
I have set the DalyBMS sleep setting to 15300 so it doesnt fall asleep and I can check whenever I want the state of the pack.
In the last few days, I have put my CPAP with a 12v adapter on this battery pack to test it in off the settings.
After two 7 hours night of sleep, the Bluetooth app still says my battery is at 100% of soc.
When the CPAP runs at low setting, it doesnt draw much in terms of AMP. Below 2 amps for sure, maybe 1 amp. The Daly/app doesnt seem to detect that such current is being drawn. So I think the Daly BMS is not sensitive enough to detect under 2 amps current. Thus the app stays at 100% all the time.
Am I right in my thinking ? any settings I should look into ?