frankz66
New Member
Hi everyone, I tried to update my Epever 6415AN with a new version 4.11 .
The problem is that I run the update program, I load the firmware but at the time of programming the controller crashes or rather remains frozen for example in the battery or pv indications, it depends on the moment I try to perform the update.
I was worried that it had been damaged, but as soon as I disconnected the battery cables both the positive and the negative started working again. For programming I used the usb to rs485 cable which has always allowed me to use Epsolar .
The problem is that I run the update program, I load the firmware but at the time of programming the controller crashes or rather remains frozen for example in the battery or pv indications, it depends on the moment I try to perform the update.
I was worried that it had been damaged, but as soon as I disconnected the battery cables both the positive and the negative started working again. For programming I used the usb to rs485 cable which has always allowed me to use Epsolar .