frankz66
New Member
Hello everyone , I know that it is possible to configure 2 epever in parallel . In my configuration I have du strings 2s2p and a drop cable that goes to the eepever . If you want to use a single descent that is connected to the 25 amp residual current circuit breaker. I was thinking of putting in parallel the output from the switch that will go to the two epever, connect the second epever to the equipotential bar where there are all the positive cables and the other to the negative cables. Faithfully copy the parameters of the current epever . Is it correct? I should adopt this solution as it is difficult for me to pass another pair of cables and separate the strings.