JK active BMS lead removal

[JJJJ]

Ok. I am totally dense on this. I did ask someone how to remove the extra wire leads. They quickly responded but I am hitting a mental brick wall. It was suggested to use a small sharp object to move the small finger which held the wire. Alas, I confess I have not had any success and want to make sure I don't damage anything. Any suggestions?

Thank you in advance.

 

[sunshine_eggo]

Take a picture here with the connector/wires flat on the surface.:

 

[JJJJ]

Here you go:

 

[sunshine_eggo]

This may be a very small tab you can press in towards the table and pull out the wire:

 

[Zwy]

Ok. I am totally dense on this. I did ask someone how to remove the extra wire leads. They quickly responded but I am hitting a mental brick wall. It was suggested to use a small sharp object to move the small finger which held the wire. Alas, I confess I have not had any success and want to make sure I don't damage anything. Any suggestions?

Thank you in advance.


View attachment 140059

With the notch in the backside, it might be released from the rear. Usually a plastic tab sticks out.

 

[Zwy]

Overkill/JBD is the same type of terminal, I just looked at one on the bench.

 

[JJJJ]

The other side

 

[Zwy]

I believe these are similar to JST terminals.

 

[JJJJ]

Thank you everyone! OK, so I picked up some of these dental tools. Here is the one I used.