Jk bms app reading different from cells reading

[J_Iu]

My jk bms is reading 54.36v on my phone but testing each of the wire, everything read correctly, the last reading on the cable was 51.26v as I was testing each wire.
I tested the individual cells using multimeter and I got 3.202v
What could make the bms on my phone to read 54.36v instead of 51.26v?

 

[DIYrich]

Calibration error. One of the Advanced settings.

 

[J_Iu]

Calibration error. One of the Advanced settings.

I went further to check reading of individual cells with multimeter and 10 cells were reading 3.203v each. 4 cells were reading 3.202v each while 2 cells were reading 3.201v each. Total 51.24v.
I just installed Victron BMV 712 and I've not set it yet and the reading was 51.21v.
I switched on the hybrid inverter and the reading was 51.1v and this time, the BMV read 51.14v.
Meanwhile, the bms on my phone is reading 54.35v

 

[DIYrich]

Did you change the calibration voltage on the bms?

 

[J_Iu]

Did you change the calibration voltage on the bms?

No

 

[J_Iu]

Should I reset the calibrating voltage?

 

[DIYrich]

Should I reset the calibrating voltage?

Yes. That's what it is for.

 

[J_Iu]

Yes. That's what it is for.

Thanks

 

[J_Iu]

SCANNED EVE QR CODE SHOWING 0.0WH AND 0.0AH
Is this normal?