Please post the individual cell voltages.
Not fully charged.My smart lifepo4 is fully charged but showing 0% soc and 10.458v
The cells aret dead . Its the bms seeing 10.485. i was messingNot fully charged.
Dead
I accidentally pressed something i think i turned off the dmos and in trying yo turn it back on thats when i daw the 10.485According to the individual cell voltages the pack voltage is 13.891 volts not 10.458 as you stated in your individual post.
Also cell #2 is very close to high cell disconnect.
Something is not adding up.
Is the discharge path still open?
The pack level low voltage disconnect is probably 10 volts.Would it make sense for me to go into settings and change the lowvoltage fisconnect to something lower than 10.485? And how would that affect charging cuz now when i connect my ac charger it just turns on and it says full after like 10 seconds.
No i was messing around in the setting i accidentally turned off dmos and when i turned it back on it was showing the voltage at 10.***Your BMS is likely protecting the pack because of that high cell.
What voltage are you charging them at?
Looks like one of the cell bms wires are not connected to the cell properly.
You certainly need to balance these cells.