MT50 Issues, Not able to set some parameters

[fratermus]

he Mt50 on 12v Sealed battery mode will have a 24v operating spec for overcharge-undercharge

This has not been my experience on any of the EpEver controllers I have owned. If you have a video of the controller flipping to 24v when selecting SEALED I'd be happy to corrected.

 

[GLC]

I'm the same, after I program my epevers I put the mt50 back in it's box in my drawer.

With running 4 systems now, I have them all on MT50's . They are hooked up all the time so I can monitor each system individually.

 

[Torsten_UAE]

You have to stick to certain rules when setting the parameters.

The main issue I ran into was keeping the boost reconnect higher than to LV reconnect

This was the helpful information that solves the problem, Thanks.

 

[GLC]

This was the helpful information that solves the problem, Thanks.

Programming the MT50 is actually easier if you start from the end to the beginning.

 

[12VoltInstalls]

Programming the MT50 is actually easier if you start from the end to the beginning.

I couldn’t get some settings to stick. I gave up and used the laptop and all was fine.