bear0214
New Member
This is a new Renogy 500A monitor install and there are a few of the user specified settings in the monitor I am unsure of and would like feedback on the correct specs.
My batteries are 2 - 81Ah Interstate deep cycle RV SRM-24. I called Interstate where I bought the batteries and the guy gave me some information but he could not answer the specs regarding Zero Voltage, Power Off, Zero Capacity Voltage, Shutdown Voltage, Low Capacity Alarm, and Battery Attenuation Ratio.
Need some help with these please.
CAP setting is 81Ah X 2 = 162 correct?
Full V = 12.9V fully charged?
Zero V = I put 12.45 (50% discharged battery) ? Not sure about this
PowOff = (50% discharged battery) ? Not sure about this - Will the monitor shut off the system at this level?
Alarm = (50% discharged battery) ? Not sure about this
Atten = Is this a calculation done by the monitor itself? or do I need to set this?
Thanks for your help.
John in Montana
My batteries are 2 - 81Ah Interstate deep cycle RV SRM-24. I called Interstate where I bought the batteries and the guy gave me some information but he could not answer the specs regarding Zero Voltage, Power Off, Zero Capacity Voltage, Shutdown Voltage, Low Capacity Alarm, and Battery Attenuation Ratio.
Need some help with these please.
CAP setting is 81Ah X 2 = 162 correct?
Full V = 12.9V fully charged?
Zero V = I put 12.45 (50% discharged battery) ? Not sure about this
PowOff = (50% discharged battery) ? Not sure about this - Will the monitor shut off the system at this level?
Alarm = (50% discharged battery) ? Not sure about this
Atten = Is this a calculation done by the monitor itself? or do I need to set this?
Thanks for your help.
John in Montana