Exactly!Great info. I taped half of mine with Kapton so I guess I'm half good . Since we likely will not deplete to anywhere near zero and don't need to charge to 100, we'll probably be just fine either way right?
It's probably with my heli-coils! I got my meter but none of my other goodies. Damn...Exactly!
Looks like Amazon screwed up and my charger didn't arrive on today's UPS truck. Hoping it's not lost and will show tomorrow.
Grinding out that hole for the gauge absolutely sucked by the way. I used my Ryobi zip tool with a grinding stone attachment. Took FOREVER. I'm sure there is a better way.
Also did a full cut and meter is accurate. The Daly BMS after a full cut was extremely hot. I sent a message to them to ask if that's normal. Likely POS BMS and will likely replace it with the overkill BMS.I have a step bit but not one that is 2". I used what I had on hand. I like that punch kit though. Might need to grab one of those for future projects. The steel for the mower panel looks like 1/8". Also, I just did a full cut with the new meter. Less than 1% difference in capacity between the meter and the BMS. Not bad at all.