Torque specs for EVE LF304 dual bolt welded terminal

[Mirlen]

What torque should be used for the EVE LF304 with the new dual bolt matte finish welded terminals? Am putting together a 4 cell 12v, waiting on some proper lugs for wiring the BMS so just have them at about 4nm right now for testing. I did some searching but wasn't clear what these terminals would need as a lot of talk was about the single post terminals. These have the helicoils in them.

 

[Mirlen]

I see the spec listed on EVE documents is 6 Nm for the cell terminal, but nothing specific to the bolt-on terminal.

 

[hardtop]

Mine are hand tight with a philips.

 

[740GLE]

Mine are hand tight with a philips.

Careful charging without a BMS like that, it can go south real quick even if the total pack stays under 14.4v.

 

[Mirlen]

I went with 4.5nm, nothing broke. Where's the sun?