Hello all, I'm having a mind boggling problem with my charge controller. I have 4 130 watt panels wired in series running through a 16 amp dc double pole breaker and then on to a 40amp epever tracer BN serries charge controller. I have one kilovault HLX 12V 300 AH battery. I have a 40amp inline breaker between the battery and the charge controller on 6ga wire. The issue is that the charge controller will cut all power (dc load, charging, connected MT50 interface) for just a second at approximately 30amps charge current. It turns back on after that quick second and resumes normal charging and everything until it reaches 30amps again. The same issue has persisted with a Renogy rover 40 amp charge controller as well as my current EPever. So, it seems that the problem is something else with in my system, not the controller. I have also determined that my battery is not momentarily turning off so the issue is probably not the battery. I have checked every connection for tightness, tried turning off the dc load, double checked that all wires are correct gauge, multi metered everywhere to see if there were any strange readings, no breakers are tripping, no error codes appear.... everything seems fine but the issue persists. I talked to Kilovault tech support and they couldn't figure anything out either. Does anyone have a clue what the problem could be or heard of anyone with the same issue?