I bought 2 Ampere Time LiFePO4 12v 200 amp batteries and connected the and series. I connected them to my charge controller a Triron4210N with a MT50 as an interface. I have run into a couple of problems that I am hoping that someone can help with. The best setting I could select was "Sealed" then select "User" I tried to set the parameters double that was in the product overview. I tried to set the Over voltage Disconnect to 30 volts but the lowest I could go was 31 volts without getting an error. The product overview did not any listing for Temp Comp. Coeff 3 mv/C/2V. I sit it to Temp Comp. Coeff 0 mv/C/2V.
Can any one please provide the complete setup listings for the two LiFePO4 12V 200 Ah batteries in series.
Thank you,
J.
Can any one please provide the complete setup listings for the two LiFePO4 12V 200 Ah batteries in series.
Thank you,
J.