For sale is a complete Outback Power system. Buy it all or individual components. Asking prices listed below. Items are a Radian GS8048A hybrid inverter, an Outback GSLC 120/240 175 PV with a built-in Outback Flexnet battery monitor and an added 80 amp breaker that directly supports 3 Flexmax 60 or 80 charge controllers. Available are 3 Flexmax 60 charge controllers, one Outback Hub 10.3 and an Outback Mate 3S. All items are updated to the latest firmware. All items were originally installed by a master electrician and carefully removed from service and cleaned. Displays on the Mate and charge controllers are perfect, without defects. Indoor use only. Installation in an enclosed area such as a garage, basement, shed, etc. The system was connected to the internet through the ethernet port on the back of the Mate 3S and then remote computer control is via the Outback Power Optics RE web server interface which allows for remote monitoring and control. The system is California Energy Commission certified and UL approved for connection to the grid. This inverter outputs 8,000 watts of 1 phase 120/240 volt power. Battery input is nominal 48 volts. Flexible time of use modes are supported to reduce grid usage during high rate periods. Supported batteries include flooded lead acid, AGM and lithium. Inverter modes include off-grid using PV and battery in a mix, backup of grid, support of low grid power, selling to the grid and generator. AC input by grid or generator is 240 volts at 50 amps. Pass through the inverter of grid power or generator is 12,000 watts. The inverter also contains an onboard 240 volt 30 amp battery charger which can use either grid or generator to charge batteries. The output power as well as voltage to charge and recharge the batteries is easily configurable to the desired amounts for your needs. The inverter is easily capable of parallel functioning by stacking additional inverters. The inverter is transformer-based and capable of starting heavy electrical loads using large inrush currents. I have personally started a 5 HP Delta Unisaw motor with this inverter. The GSLC load center connects directly to the bottom of the inverter to form a single one-piece configuration. The load center contains all of the buss bars and circuit breakers for the inverter, sub-panel, AC and generator inputs, bypass switches, battery breakers, charge controller breakers and GFI breakers. The charge controllers can be directly programmed independently of the other components of the system. They can act as stand-alone units to charge a battery bank from a PV array. Or, their output can be pooled to form a single larger charge controller via use of the Mate 3S and Optics RE. Taken together, the three charge controllers can supply up to 180 amps of power at voltages to charge and even equalize a 48 volt battery bank (approximately 10,000 watts of PV input is supported). The charge controllers can be remotely programmed via the Mate 3S and Optics RE. The Flexnet controller will report the amperage use of the battery system and report a state of charge level through colored LEDs on the load center or via display on the Mate 3S panel as a percentage as well as in Optics RE. It is very accurate with flooded batteries and AGM and will work with lithium batteries, but accuracy is more dependent on the brand, as most lithium batteries have their own battery manager. Outback printed manuals (the originals) and cables come with each piece of equipment. The inverter weight is 125 pounds. Local pickup can be arranged in San Diego county. Otherwise, it is suggested that it be shipped via freight or using a service such as Uship.com. For those new to Uship, this is a reliable service where you list your item to be shipped and and shippers bid to pick up and deliver your item using available cargo space they have on their existing travel routes. I have used this service and had excellent results and saved money. The other items such as Mate 3S, charge controllers, load center could be individually shipped by the common carriers such as UPS. I could ship for you out of the USA using USPS, UPS, etc.
I have many, many photos and closeups, too many to list on the site. If you send me a PM or an e-mail address of what you want to see, I can send a photo or even arrange a video call with you.
Outback Power Radian inverter is made in the USA, and with the load center is commercial grade. This is one of the best systems you can install for worry-free power.
ASKING PRICES:
RADIAN INVERTER GS8048A: $3,200.00
OUTBACK GSLC 120/240 175 PV 175 + 80 AMP 3RD BREAKER FOR CHARGER: $1,000.00
MATE 3S: $400.00
HUB 10.3: $225.00
FLEXMAX 60 CHARGE CONTROLLERS (3 AVAILABLE): $350.00 EACH OR ALL THREE FOR $1,000.00
OR BUY IT ALL FOR $5,500.00
I have many, many photos and closeups, too many to list on the site. If you send me a PM or an e-mail address of what you want to see, I can send a photo or even arrange a video call with you.
Outback Power Radian inverter is made in the USA, and with the load center is commercial grade. This is one of the best systems you can install for worry-free power.
ASKING PRICES:
RADIAN INVERTER GS8048A: $3,200.00
OUTBACK GSLC 120/240 175 PV 175 + 80 AMP 3RD BREAKER FOR CHARGER: $1,000.00
MATE 3S: $400.00
HUB 10.3: $225.00
FLEXMAX 60 CHARGE CONTROLLERS (3 AVAILABLE): $350.00 EACH OR ALL THREE FOR $1,000.00
OR BUY IT ALL FOR $5,500.00
Attachments
Last edited: