I installed my aili bat monitor in between the
neg bus bar ( all - batteries ) and my 6000watt
inverter ( neg side input)
the monitor works great
Shows voltage
I adjusted the batt ah in the settings
Shows amp draw
Full battery is allready programmed to 100%
Now my problem
After using ( discharge) , my inverter batt % goes to
50% ( for example)
So the next morning the charge controller starts charging the batteries
But the % on the monitor stays at 50% , it doesnt go to 100% ( full charge batteries)
am i missing something here??
neg bus bar ( all - batteries ) and my 6000watt
inverter ( neg side input)
the monitor works great
Shows voltage
I adjusted the batt ah in the settings
Shows amp draw
Full battery is allready programmed to 100%
Now my problem
After using ( discharge) , my inverter batt % goes to
50% ( for example)
So the next morning the charge controller starts charging the batteries
But the % on the monitor stays at 50% , it doesnt go to 100% ( full charge batteries)
am i missing something here??