EG4 18kPV Q+A general thread

BKY2003 · Tuesday at 9:08 AM

ksmithaz1 said:
Note: 54v * 250A = 13500 watts

Just connect your chargerverter to the load side. Then you have 19,000 watts charging. Just kidding, hopefully they can increase the Charging amps.

EG4TechSolutionsTeam · Tuesday at 9:10 AM

Brucey said:
Hi, is the 12kPV model in that list, I don't see it. Same as the 18kpv version?

I believe it is not currently listed on the warranty registration because the 12kPV is still in pre-order with most of our distributors. However, I would expect the same or a similar limited warranty.

EG4TechSolutionsTeam · Tuesday at 9:11 AM

ksmithaz1 said:
@EG4TechSolutionsTeam Circling back on the battery charging issue. There is definitely an issue with parallel inverters limiting charging output to 250A. I think this should be 250A EACH. I have two 600AH battery racks each closed loop to two inverters in parallel. Both report sane information back to their respective inverters. Once I exceed ~13KW of "available" PV for charging it clips my PV until demand pops back up. (see above). What can be done to get this addressed before I get the rest of my new panels up?

I will be looking into this. Can you DM an export of your settings?

dielectric · Tuesday at 11:00 AM

Can't set the
Smart Load End Volt(V) above 55V
I have 17S batteries that's why the volts are higher than usual.
I was able to set 55V but would like 57.6V to limit the smart load to the excess PV only.
I get error "code 3" when I attempt to set anything above 55V.

EG4 18kPV Q+A general thread

BKY2003

Solar Enthusiast

EG4TechSolutionsTeam

Online Support for EG4 Electronics

EG4TechSolutionsTeam

Online Support for EG4 Electronics

dielectric

New Member

Similar threads