Ra Ma Da Sa
New Member
- Joined
- Mar 17, 2021
- Messages
- 19
I recently received my MPP Solar inverter and after connecting 6 100watt Renogy panels in series and parallel I continue to get a reading that only around 40 to 90watts of power are being detected with proper voltage reading too, the amps are far below what they should be too at about 2. I also noticed that when I turn the unit off it stays running with drastic reduction in panel power produced and load reading not available, also I seem to be unable to change the battery voltage cut off. I have 2220 amp hours of battery with 30%-50% of that being usable and a 200amp fuse. The panels are fused to with one 30amp mc4 fuse, the wires carrying the power are 10AWG because I am well under the amperage of 30. I am soon getting 4 10amp fuses to use with a four way branch connector. I do have another 6 100 watt panels that I am going to be using with this system when I make it to my Travel trailer in the next short while until then I just want to connect everything and be sure the system works as it should. Any and all advise is greatly appreciated.